MOZA SRP2 Clutch Pedal: Add a Third Pedal to Your Rig

Quick answer

Mount the MOZA RACING SRP2 Clutch Pedal to your existing SRP2 pedal base, then set pedal height and angle to match your seating position before tuning the two-stage preload. Check that your base and rig can accept a third pedal before ordering.

Steps to install and adjust the SRP2 clutch pedal

1. Confirm SRP2 base compatibility: Check that your pedal base is the SRP2 system the clutch is designed for. Common mistake: assuming any MOZA pedal base accepts it. Checkpoint: if your base is not SRP2, stop and choose a different upgrade. Compatibility is decided before installation, not during it.
2. Test-fit the pedal position on the base: With the base off the rig or accessible, offer up the clutch pedal and check that it seats cleanly on the SRP2 base mounting points. Common mistake: forcing the pedal into a position that strains the mount. Checkpoint: the pedal should sit flush before you tighten anything.
3. Mount the pedal to the base: Fasten the clutch pedal to the SRP2 base following the supplied mounting arrangement, keeping fasteners loose enough to allow adjustment. Common mistake: fully tightening before setting height and angle. Checkpoint: the pedal stays in place but can still be repositioned by hand.
4. Set pedal height and angle: Sit in your normal driving position and adjust height and angle so the clutch sits where your left foot naturally rests and can press through its travel. Common mistake: setting the pedal to look right rather than to feel right from the seat. Checkpoint: you can reach full travel without stretching or lifting your heel. Adjust from the seated position, not from standing beside the rig.
5. Tune the two-stage preload: Adjust the two-stage preload so the first stage gives a light initial feel and the second stage builds resistance toward the bite point you want. Common mistake: setting preload before height and angle are final, which forces you to redo it. Checkpoint: the pedal returns smoothly and the stages feel distinct.
6. Tighten and run a full-travel check: Tighten all fasteners, then press the clutch through its full range several times and confirm it does not contact the brake pedal, rig frame, or wiring. Common mistake: checking only the resting position. Checkpoint: no binding, rubbing, or flex at full travel. Recheck clearance after the first driving session, since fasteners can settle.

Product facts

• MOZA RACING SRP2 Clutch Pedal: The SRP2 Clutch Pedal mounts to the SRP2 pedal base and offers adjustable height, angle, and two-stage preload. You can match the clutch to your seating position and driving style instead of adapting your footwork to a fixed pedal.