How to Replace the Clutch Pedal on Your MOZA SR-P Lite

Quick Answer

To replace the clutch pedal on your MOZA SR-P Lite, disconnect the pedal set, swap the clutch pedal unit, and reconnect everything—checking alignment and firmware afterward. This guide walks you through each step.

Step-by-Step Clutch Pedal Replacement

1. Disconnect and Prepare: Unplug the SR-P Lite pedal set from your PC or wheel base. Place the pedals on a stable surface with the cable accessible. Common mistake: leaving the pedals connected while working can cause accidental inputs or short circuits. Always power down and disconnect before touching any wiring.
2. Remove the Existing Pedal Cover: Locate the pedal cover you want to replace (usually the far-left or middle position). Remove the screws or clips holding it in place, then gently pull the pedal cover off. Common mistake: forcing the cover can break the mounting tabs—use even pressure. Check for hidden screws before pulling.
3. Install the New Clutch Pedal: Align the MOZA SR-P Clutch pedal with the mounting holes on the SR-P Lite pedal set. Insert and tighten the screws or bolts, but don't overtighten—this can strip threads. Common mistake: misaligning the pedal can cause binding when you press it. Test the pedal's range of motion before fully tightening.
4. Reconnect and Calibrate: Reconnect the pedal set to your PC or wheel base. Open the MOZA Pit House software and check that the clutch pedal is recognized. Calibrate the pedal's travel range if needed. Common mistake: skipping calibration can result in inconsistent inputs or a pedal that doesn't reach 100%. Always run a quick calibration after installation.

Product Fact

• MOZA RACING SR-P Lite Clutch: The MOZA RACING SR-P Clutch is designed to be attached to the SR-P Lite Pedal set which is packaged with the MOZA Racing R5 bundle. This ensures compatibility and a straightforward install if you already own the R5 bundle, so you don't need to buy a separate pedal base.