MOZA R3 PC Wheel Stand Bundle Build Guide

Quick answer

Assemble your MOZA R3 PC Wheel Stand Bundle by mounting the R3 wheelbase, ES steering wheel, and SRP pedals onto the APEX Wheel Stand. The stand folds away with hardware attached, making it ideal for compact spaces.

Build steps

1. Unpack and inspect all components: Remove the MOZA R3 wheelbase, ES steering wheel, SRP pedal set, and APEX Wheel Stand from the box. Verify that no parts are damaged and that all mounting hardware is present. Common mistake: Forgetting to check for small screws or washers that may be taped inside the box flaps.
2. Assemble the APEX Wheel Stand base: Extend the APEX Wheel Stand to your desired width and lock the adjustment knobs. Place the stand on a level desk or table surface and tighten the clamps to secure it in place. Checkpoint: The stand must be firmly clamped; any wobble will affect force feedback accuracy.
3. Mount the MOZA R3 wheelbase: Align the R3 wheelbase mounting holes with the bracket on the APEX Wheel Stand. Insert and tighten the provided bolts using the included hex key. Ensure the wheelbase is level and centered. Common mistake: Overtightening bolts can strip the threads; tighten until snug, then stop.
4. Attach the ES steering wheel: Slide the ES steering wheel onto the R3 wheelbase shaft until it clicks into place. Tighten the locking ring by hand until it is secure. Checkpoint: Verify that the wheel does not rotate independently on the shaft—if it does, the locking ring is not tight enough.
5. Install the SRP pedal set: Position the SRP pedal set on the pedal plate of the APEX Wheel Stand. Use the mounting screws to fix the pedals in place, then connect the USB cable to your PC. Common mistake: Routing the pedal cable where it can be pinched by the stand's folding mechanism; route it along the stand's frame instead.
6. Connect and test the setup: Plug the R3 wheelbase USB cable into your PC. Launch your sim racing software and calibrate the wheelbase, wheel, and pedals in the control panel. Test full rotation and pedal travel before your first race. Checkpoint: If the wheelbase does not power on, check that the USB cable is fully seated and that your PC recognizes the device.

Product facts

• MOZA R3 PC Wheel Stand Bundle: The APEX Wheel Stand & MOZA R3 PC Sim Racing Bundle includes the R3 direct drive wheelbase, ES steering wheel, and SRP pedal set, all mounting directly onto the APEX Wheel Stand. This bundle gives you a complete direct drive starting point in one box, so you don't need to source separate components or worry about compatibility.